MC-212SD View Datasheet(PDF) - HIROSE ELECTRIC
Part Name
Description
View to exact match
MC-212SD Datasheet PDF : 3 Pages
| |||
Coil Components (SMD)
MC-200SC and MC-200SD Series
sFeatures
MC-201SC
MC-201SD
MC-212SC
MC-217SC MC-218SC
MC-211SD
MC-212SD
MC-213SD
1.Excellent High Frequency Characteristics
Insertion loss: 0.6 dB TYP.
Phase balance: ±3deg TYP.
2.Highly Reliable Design
PPS resin is used for the exterior cladding of the
cover, glass epoxy substrate is used for the board
material, and solder plating is used for the electrodes.
All these factors contribute to excellent mechanical
strength, heat resistance, and soldering qualities
sProduct Specifications
3.Suited to Automatic Mounting
Embossed tape packaging permits automatic mounting.
(Individual delivery can also be accommodated.)
Ratings
Frequency range (Note)
Characteristic impedance (Note)
Maximum Input Power
30 to 370 MHz
50 ohms, 75 ohms
0.5 W
Operating temperature range
Operating relative humidity
-10ç to +65ç
95% Max.
Note: The frequency range and the characteristic impedance will differ depending on the products.
Item
Standard
Conditions
1.Vibration
Frequency of 10 to 2000 Hz, overall amplitude of 1.52 mm,
acceleration of 98 m/s2 for 4 hours in each of 3 directions
2.Shock
3.Temperature cycle
No damage, cracks, or parts dislocation
Acceleration of 294 m/s2, sine half-wave waveform, 3 cycles in each of the 3 axis
(-60 to 55ç: 30 min. ¡ 20 to 35ç: 15 min.
¡ 125 to 128ç: 30 min. ¡ 20 to 35ç: 15 min.)
for 100 cycles
4.Corrosion resistance
No serious corrosion
qThe test method conforms to MIL-STD-202.
Exposed to 5% salt water solution for 48 hours
sMaterials
sExternal Dimensions
Part
Board
Cover
Material
Glass epoxy
PPS
Finish
Solder plating
-----------
sOrdering Information
MC - 2 0 1 S C
1
2345 6
1 Series Name: MC
4 Suffix
2 Number of Divisions
5 Board Mounting Method
Indicated by number of divisions of output. S : SMT type
3 Phase Difference
6 Characteristic Impedance
Indicated by phase difference of output. C : 75 ohms
0 : 0°
D : 50 ohms
1 : 90°
input
qThe contact numbers
are common for both the
0° type and the 90° type.
46
|
|
Share Link: 