datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

KM416L8031BT-GFZ View Datasheet(PDF) - Samsung

Part Name
Description
View to exact match
KM416L8031BT-GFZ
Samsung
Samsung Samsung
KM416L8031BT-GFZ Datasheet PDF : 49 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
128Mb DDR SDRAM
Target
3.2.3 Precharge
The precharge command is used to precharge or close a bank that has been activated. The precharge com-
mand is issued when CS, RAS and WE are low and CAS is high at the rising edge of the clock. The precharge
command can be used to precharge each bank respectively or all banks simultaneously. The bank select
addresses(BA0, BA1) are used to define which bank is precharged when the command is initiated. For write
cycle, tWR(min.) must be satisfied until the precharge command can be issued. After tRP from the precharge,
an active command to the same bank can be initiated.
Bank Selection for Precharge by Bank address bits
A10/AP
BA1
BA0
Precharge
0
0
0
Bank A Only
0
0
1
Bank B Only
0
1
0
Bank C Only
0
1
1
Bank D Only
1
X
X
All Banks
Table 5. Bank selection for precharge by Bank address bits
3.2.4 No Operation(NOP) & Device Deselect
The device should be deselected by deactivating the CS signal. In this mode DDR SDRAM should ignore
all the control inputs. The DDR SDRAMs are put in NOP mode when CS is active and by deactivating RAS,
CAS and WE. For both Deselect and NOP the device should finish the current operation when this com-
mand is issued.
- 18 of 63 -
REV. 0.61 August 9. '99
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]