CAT24WC256J-1.8TE13 View Datasheet(PDF) - Catalyst Semiconductor => Onsemi
Part Name
Description
View to exact match
CAT24WC256J-1.8TE13 Datasheet PDF : 10 Pages
| |||
CAT24WC256
FUNCTIONAL DESCRIPTION
The CAT24WC256 supports the I2C Bus data transmis-
sion protocol. This Inter-Integrated Circuit Bus protocol
defines any device that sends data to the bus to be a
transmitter and any device receiving data to be a re-
ceiver. The transfer is controlled by the Master device
which generates the serial clock and all START and
STOP conditions for bus access. The CAT24WC256
operates as a Slave device. Both the Master device and
Slave device can operate as either transmitter or re-
ceiver, but the Master device controls which mode is
activated.
PIN DESCRIPTIONS
SCL: Serial Clock
The serial clock input clocks all data transferred into or
out of the device.
SDA: Serial Data/Address
The bidirectional serial data/address pin is used to
transfer all data into and out of the device. The SDA pin
is an open drain output and can be wire-ORed with other
open drain or open collector outputs.
WP: Write Protect
This input, when tied to GND, allows write operations to
the entire memory. When this pin is tied to Vcc, the
entire memory is write protected. When left floating,
memory is unprotected.
A0, A1: Device Address Inputs
These pins are hardwired or left connected. When
hardwired, up to four CAT24WC256's may be addressed
on a single bus system. When the pins are left uncon-
nected, the default values are zero.
Figure 1. Bus Timing
tF
SCL
tSU:STA
SDA IN
SDA OUT
tHIGH
tR
tLOW
tLOW
tHD:DAT
tHD:STA
tSU:DAT
tAA
tDH
tSU:STO
tBUF
Figure 2. Write Cycle Timing
SCL
SDA
8TH BIT
BYTE n
ACK
Figure 3. Start/Stop Timing
SDA
SCL
Doc. No. 1031, Rev. F
START BIT
tWR
STOP
CONDITION
START
CONDITION
ADDRESS
STOP BIT
4
|
|
Share Link: 