datasheetbank_Logo   Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site
Part Name :   

ST6201BT1 View Datasheet(PDF) - STMicroelectronics

Part NameDescriptionManufacturer
ST6201BT1 8-bit MCUs with A/D converter,two timers, oscillator safeguard & safe reset ST-Microelectronics
STMicroelectronics ST-Microelectronics
ST6201BT1 Datasheet PDF : 100 Pages
First Prev 31 32 33 34 35 36 37 38 39 40 Next Last
ST6200C ST6201C ST6203C
6.2 WAIT MODE
The MCU goes into WAIT mode as soon as the
WAIT instruction is executed. This has the follow-
ing effects:
– Program execution is stopped, the microcontrol-
ler software can be considered as being in a “fro-
zen” state.
– RAM contents and peripheral registers are pre-
served as long as the power supply voltage is
higher than the RAM retention voltage.
– The oscillator is kept running to provide a clock
to the peripherals; they are still active.
WAIT mode can be used when the user wants to
reduce the MCU power consumption during idle
periods, while not losing track of time or the ability
to monitor external events. WAIT mode places the
MCU in a low power consumption mode by stop-
ping the CPU. The active oscillator (main oscillator
or LFAO) is kept running in order to provide a clock
signal to the peripherals.
If the power consumption has to be further re-
duced, the Low Frequency Auxiliary Oscillator
(LFAO) can be used in place of the main oscillator,
if its operating frequency is lower. If required, the
LFAO must be switched on before entering WAIT
mode.
Exit from Wait mode
The MCU remains in WAIT mode until one of the
following events occurs:
– RESET (Watchdog, LVD or RESET pin)
– A peripheral interrupt (timer, ADC,...),
– An external interrupt (I/O port, NMI)
The Program Counter then branches to the start-
ing address of the interrupt or RESET service rou-
tine. Refer to Figure 20.
See also Section 6.4.1.
Figure 20. WAIT Mode Flowchart
WAIT INSTRUCTION
OSCILLATOR
On
Clock to PERIPHERALS Yes
Clock to CPU
No
N
N
INTERRUPT
RESET
Y
Y
OSCILLATOR
Restart
Clock to PERIPHERALS Yes
Clock to CPU
Yes
2048
CLOCK CYCLE
DELAY
OSCILLATOR
On
Clock to PERIPHERALS Yes
Clock to CPU
Yes
FETCH RESET VECTOR
OR SERVICE INTERRUPT
32/100
1
Doc ID 4563 Rev 5
Direct download click here
 

Share Link : ST-Microelectronics
All Rights Reserved © datasheetbank.com 2014 - 2019 [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]