ST6201CB1 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

View to exact match

ST6201CB1

8-bit MCUs with A/D converter,two timers, oscillator safeguard & safe reset

STMicroelectronics 

ST6200C ST6201C ST6203C

RESET (Cont’d)

5.3.3 RESET Pin

The RESET pin may be connected to a device on

the application board in order to reset the MCU if

required. The RESET pin may be pulled low in

RUN, WAIT or STOP mode. This input can be

used to reset the internal state of the MCU and en-

sure it starts-up correctly. The pin, which is con-

nected to an internal pull-up, is active low and fea-

tures a Schmitt trigger input. A delay (2048 clock

cycles) added to the external signal ensures that

even short pulses on the RESET pin are accepted

as valid, provided VDD has completed its rising

phase and that the oscillator is running correctly

(normal RUN or WAIT modes). The MCU is kept in

the Reset state as long as the RESET pin is held

low.

Figure 14. Reset Block Diagram

If the RESET pin is grounded while the MCU is in

RUN or WAIT modes, processing of the user pro-

gram is stopped (RUN mode only), the I/O ports

are configured as inputs with pull-up resistors and

the main oscillator is restarted. When the level on

the RESET pin then goes high, the initialization se-

quence is executed at the end of the internal delay

period.

If the RESET pin is grounded while the MCU is in

STOP mode, the oscillator starts up and all the I/O

ports are configured as inputs with pull-up resis-

tors. When the RESET pin level then goes high,

the initialization sequence is executed at the end

of the internal delay period.

A simple external RESET circuitry is shown in Fig-

ure 15. For more details, please refer to the appli-

cation note AN669.

RESET

VDD

RPU

fINT

RESD1)

1) Resistive ESD protection.

INTERNAL

RESET

WATCHDOG RESET

LVD RESET

24/100

1

Doc ID 4563 Rev 5

Share Link: