6754MR View Datasheet(PDF) - Fairchild Semiconductor
Part Name
Description
View to exact match
6754MR Datasheet PDF : 14 Pages
| |||
Marking Information
ZXYTT
6754MR
TPM
Pin Configuration
ZXYTT
6754ML
TPM
Figure 3. Top Mark
F - Fairchild Logo
Z - Plant Code
X - 1-Digit Year Code
Y - 1-Digit Week Code
TT - 2-Digit Die Run Code
T - Package Type (M=SOP)
P - Y: Package (Green)
M - Manufacture Flow Code
SOP-8
GND
1
8
GATE
FB
2
7
VDD
NC
3
6
SENSE
HV
4
5
RT
Figure 4. Pin Configuration (Top View)
Pin Definitions
Pin #
1
2
3
4
5
6
7
8
Name Description
GND
Ground. This pin is used for the ground potential of all the pins. A 0.1µF decoupling capacitor
placed between VDD and GND is recommended.
Feedback. The output voltage feedback information from the external compensation circuit is
FB
fed into this pin. The PWM duty cycle is determined by this pin and the current-sense signal
from Pin 6. FAN6754 performs an open-loop protection (OLP); if the FB voltage is higher than a
threshold voltage (around 4.6V) for more than 55ms, the controller latches off the PWM.
NC No Connection.
High Voltage Startup. This pin is connected to the line input via a 1N4007 and 200k0 resistors
HV
to achieve brownout and high/low line compensation. Once the voltage on the HV pin is lower
than the brownout voltage, PWM output turns off. High/low line compensation dominates the
cycle-by-cycle current limiting to achieve constant output power limiting with universal input.
Over-Temperature Protection. An external NTC thermistor is connected from this pin to GND.
RT The impedance of the NTC decreases at high temperatures. Once the voltage on the RT pin
drops below the threshold voltage, the controller latches off the PWM.
SENSE
Current Sense. This pin is used to sense the MOSFET current for the current-mode PWM and
current limiting.
VDD
Supply Voltage. IC operating current and MOSFET driving current are supplied using this pin.
This pin is connected to an external bulk capacitor of typically 47µF. The threshold voltage for
turn-on and turn-off is 16.5V and 9V, respectively. The operating current is lower than 2mA.
GATE
Gate Drive Output. The totem-pole output driver for the power MOSFET. It is internally clamped
below 13V.
© 2009 Fairchild Semiconductor Corporation
FAN6754 • Rev. 1.0.1
3
www.fairchildsemi.com
|
|
Share Link: 