|Número de pieza||componentes Descripción||fabricante|
|E-L6219DSA||Stepper motor driver for automotive range|
|E-L6219DSA Datasheet PDF : 15 Pages |
The pulse generator is a monostable triggered on the positive going edge of the comparator
output. The monostable output is high during the pulse time, toff, which is determined by the
time components Rt and Ct.
toff = 1.1 · RtCt
The single pulse switches off the power feed to the motor winding, causing the winding
current to decrease during toff. If a new trigger signal should occur during toff, it is ignored.
The output stage contains four Darlington transistors (source drivers) four saturated
transistors (sink drivers) and eight diodes, connected in two H bridge.
Figure 4. Principle operating sequence
The source transistors are used to switch the power supplied to the motor winding, thus
driving a constant current through the winding. It should be noted however, that is not
permitted to short circuit the outputs.
|Direct download click here|
|Share Link :|
|All Rights Reserved © datasheetbank.com 2014 - 2019 [ Política De Privacidad ]|