M38747MCT-XXXG View Datasheet(PDF) - MITSUBISHI ELECTRIC

Part Name

Description

View to exact match

M38747MCT-XXXG

Single-chip 8-bit CMOS microcomputer. ROM 61440 bytes, RAM 2048 bytes. Mask ROM version.

MITSUBISHI ELECTRIC  

MITSUBISHI MICROCOMPUTERS

3874 Group

SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER

Timer 1, Timer 2, Timer 3

Timer 1, timer 2, and timer 3 are 8-bit timers. The count source for

each timer can be selected by timer 123 mode register.

q Timer 2 write control

When the timer 2 write control bit is “1”, and the value is written in

the address of timer 2, the value is loaded only in the latch. The

value in the latch is loaded in timer 2 after timer 2 underflows.

When the timer 2 write control bit is “0”, and the value is written in

the address of timer 2, the value is loaded in the timer 2 and the

latch at the same time.

q Timer 2 output control

An inversion signal from TOUT pin is output each time timer 2

underflows.

In this case, set the port P50 direction register to the output mode.

s Note

q Timer 1 to timer 3

When the count source of timer 1 to 3 is changed, the timer count-

ing value may be changed large because a thin pulse is generated

in count input of timer. If timer 1 output is selected as the count

source of timer 2 or timer 3, when timer 1 is written, the counting

value of timer 2 or timer 3 may be changed large because a thin

pulse is generated in timer 1 output.

Therefore, set the value of timer in the order of timer 1, timer 2 and

timer 3 after the count source selection of timer 1 to 3.

b7

b0

Timer 123 mode register

(T123M :address 002916)

TOUT output active edge switch bit

0 : Start at “H” output

1 : Start at “L” output

TOUT output control bit

0 : TOUT output disabled

1 : TOUT output enabled

Timer 2 write control bit

0 : Write data in latch and counter

1 : Write data in latch only

Timer 2 count source selection bit

0 : Timer 1 output

1 : f(XIN)/16

(or f(XCIN)/16 in low-speed mode)

Timer 3 count source selection bit

0 : Timer 1 output

1 : f(XIN)/16

(or f(XCIN)/16 in low-speed mode)

Timer 1 count source selection bit

0 : f(XIN)/16

(or f(XCIN)/16 in low-speed mode)

1 : f(XCIN)

Not used (return “0” when read)

Note : Internal clock φ is f(XCIN)/2 in the low-speed mode.

Fig. 25 Structure of timer 123 mode register

33

Share Link: