ST24E16 View Datasheet(PDF) - STMicroelectronics
Part Name
Description
View to exact match
ST24E16 Datasheet PDF : 16 Pages
| |||
ST24E16, ST25E16
Figure 6. I2C Bus Protocol
SCL
SDA
START
CONDITION
SDA
SDA
INPUT CHANGE
STOP
CONDITION
SCL
SDA
1
2
3
MSB
START
CONDITION
SCL
SDA
1
2
3
MSB
7
8
9
ACK
7
8
9
ACK
STOP
CONDITION
AI00792
Write Operations
Following a START condition the master sends a
device select code with the RW bit reset to ’0’. The
ST24/25E16 acknowledge this and waits for 2
bytes of address. These 2 address bytes (8 bits
each) provide access to any of the 8 blocks of 256
bytes each. Writing in the ST24/25E16 may be
inhibited if input pin WC is taken high.
For the ST24/25E16 versions, any write command
with WC = ’1’ (during a period of time from the
START condition untill the end of the 2 Bytes
Address) will not modify data and will NOT be
acknowledged on data bytes, as in Figure 9.
Byte Write. In the Byte Write mode the master
sends one data byte, which is acknowledged by the
ST24/25E16. The master then terminates the
transfer by generating a STOP condition.
Page Write. The Page Write mode allows up to 16
bytes to be written in a single write cycle, provided
that they are all located in the same row of 16 bytes
in the memory, that is the same Address bits (b10-
b4). The master sends one up to 16 bytes of data,
which are each acknowledged by the ST24/25E16.
After each byte is transfered, the internal byte
address counter (4 Least Significant Bits only) is
incremented. The transfer is terminated by the
master generating a STOP condition. Care must be
taken to avoid address counter ’roll-over’ which
8/16
|
|
Share Link: 